wiring oil and air/fuel guages

[2show2furious]

how???
what do u wire them to?
for the oil pressure gauge did u wire it to the oil sensor? what?

im planning to buy both sometime this month and just want to kno what to look for, thanks.


;)

[NutBucket]

You need to buy a new oil pressure sender. The one that is stock simple comes "on" when pressure drops below about 10psi. To wire an oil pressure guage you need a variable signal. Air/fuel wires to your O2 sensor. However, the stock O2 doesn't tell you all that much so its more of a light show.

[stosstruppen]

depending on the brand of o2 senser gauge you get its a pretty light show

[NutBucket]

depending on the brand of o2 senser gauge you get its a pretty light show

If its not a light show your O2 is f'd.

[accordztech]

they come with directions...air is easy...just have to find the line from the ecu or the o2 sensor, and route it to the guage.

the oil is a little bit differnt. i think its a 24mm nut that has to be taken out and bypassed with the kit that you are going to buy for it. usually if u buy a oil pressure guage...it comes with the kit....

then you just wire the power wire, then wire it to the secondary post...then ground it, then attach the sensor to the adapter on the oil pressure sensor...and tada its done.

it comes with instructions...just follow that and you will be fine, the only bitch is to take off the oil pressure sensor..

[wagsaccordsir]

Hold tight man... I am searching for a PDF file that I have saved somewhere and then I will get it posted. Hang tight!!