PDA

View Full Version : h23 pistons or stroker kit?



cb9h23
November 16th, 2004, 11:58 AM
starting a proj. who makes pistons? or have you ever seen a stroker kit?
h23 all motor hoping for 300ish hp 275tq. @ fly wheel.w/o n2o. w/ p&p head, cams, over bore block w/ raised compression pistons. this will be a long term project getting in no rush @ all. so i may end up h22 head in the end. not concerned w/ high rpms looking for low end streetable use. (75% set on h23 head) don't car about vtec. also too much of a premium for the h22 stuff.

BustedLX
November 18th, 2004, 06:59 PM
300hp all motor is going to be pretty damn expensive. I think what you should do is consider other people with similar setups so you can get and idea of what to expect.

But for example 2point6 is running a fully built and stroked H22A and dropping down about 250 all motor whp and running 13.10's. This is a fully built engine with about 20 grand worth of work in it.

All motor power is the hardest to make, I think your bar is set alittle to high.